| Specification: | The N20 meter is a digital programmable panel instrument destined for measurements of d.c. voltages, d.c. currents or temperature. The readout display is a LED display which enables the exposition of results in red, green or orange colour.
Parameters of the N20 meter:
* input:
- d.c. current: 0/ 4...20mA; ± 20mA
- d.c. voltage: 0...60mV; 0...10V; ± 10V
- temperature: Pt100, J, K
* 2 alarm outputs of OC type ( 4 types of alarms) signaled by highlight of the alarm index,
* protection level ensured by the housing: IP65,
* readout field: 5 three-colour LED displays of 14 mm height,
* highlighted measuring units,
* supply: 85...253 V a.c./ d.c. or 20...40 V a.c./ d.c.
* overall dimensions: 96 x 48 x 64 mm.
For the configuration of the N20 is destined LPCon program. The meter must be connected with the PC computer through a PD14 converter.
Parameters which can be reprogrammed are as follows:
* display colour, individually in three intervals,
* thresholds of displayed overflows,
* display precision of the result ( decimal point) ,
* highlight of the unit,
* kind of the measured signal a.c. or a.c. + d.c. ( True RMS) ,
* averaging time of the measurement,
* recounting of indications ( individual characteristic) ,
* two alarms of OC type operating in six working modes.
The N20Z meter is a digital programmable panel instrument destined for measurements of a.c. voltages, a.c. currents, or frequency. The readout display is a LED display which enables the exposition of results in red, green or orange colour.
Parameters of the N20Z meter:
* input:
- a.c. current: 1 A, 5 A,
- a.c. voltage: 100 V, 300 V, 500 V
- frequency: 20...50 Hz.
* 2 alarm outputs of OC type ( 4 types of alarms) signaled by highlight of the alarm index,
* protection level ensured by the housing: IP65,
* readout field: 5 three-colour LED displays of 14 mm height,
* highlighted measuring units,
* supply: 85...253 V a.c./ d.c. or 20...40 V a.c./ d.c.
* overall dimensions: 96 x 48 x 64 mm.
For the configuration of the N20Z is destined LPCon program. The meter must be connected with the PC computer through a PD14 converter.
Parameters which can be reprogrammed are as follows:
* display colour, individually in three intervals,
* thresholds of displayed overflows,
* display precision of the result ( decimal point) ,
* highlight of the unit,
* kind of the measured signal a.c. or a.c. + d.c. ( True RMS) ,
* averaging time of the measurement,
* recounting of indications ( individual characteristic) ,
* two alarms of OC type operating in six working modes. |
)